GE VIVID E9 Service Manual page 543

GE H
EALTHCARE
D GA091568, R
IRECTION
8-9-1-3 Rear Casters removal procedure
1.) Turn Front Casters so they are pointing forwards.
2.) Activate Direction Lock.
3.) Put the Bevel Edged Board on the floor.
PRIOR TO ELEVATING SCANNER, VERIFY THAT THE FLOATING OPERATOR PANEL
WARNING WARNING
IS LOCKED IN ITS LOWEST, PARKING POSITION.
USE EXTREME CAUTION AS LONG AS VIVID E9 IS UN-STABLE, NOT RESTING ON ALL
WARNING WARNING
FOUR CASTERS.
4.) Pull the VIVID E9 backwards up the board incline. This will lift the Rear Wheel on the opposite side
of the System from the floor.
5.) Turn the Rear Caster that stands on the Bevel Edged Board in the direction as shown in
212.
Figure 8-212 Pull VIVID E9 backwards up the board incline
6.) Activate the brakes.
7.) The VIVID E9 is now nearly balanced between one Front and one Rear Caster.
8.) Make the VIVID E9 rest on both Front Casters and lift the Rear Caster. Put the Wooden Wedge
under the chassis. This will stabilize the VIVID E9 with one Rear Caster free from the floor. This
Rear Caster can now be removed.
9.) Unscrew and remove the fixing bolt. Save the bolt for later use.
10.)Remove the Rear Caster.
5
EVISION
Chapter 8 - Replacement procedures
VIVID E9 S M
ERVICE ANUAL
Figure 8-
8 - 209