Service Safety Considerations; Faq - Frequently Asked Questions; High System Temperature Error; Reset The Bep From A Hang - GE VIVID E9 Service Manual

Hide thumbs Also See for VIVID E9:

Table of Contents

Service Safety Considerations

DANGEROUS VOLTAGES, CAPABLE OF CAUSING DEATH, ARE PRESENT IN

THIS EQUIPMENT. USE EXTREME CAUTION WHEN HANDLING, TESTING AND

IF THE COVERS ARE REMOVED FROM AN OPERATING VIVID E9, SOME METAL

SURFACES MAY BE WARM ENOUGH TO POSE A POTENTIAL HEAT HAZARD IF

TOUCHED, EVEN WHILE IN SHUT DOWN MODE.

USE ALL PERSONAL PROTECTION EQUIPMENT (PPE) SUCH AS GLOVES, SAFETY

SHOES, SAFETY GLASSES, AND KNEELING PAD, TO REDUCE THE RISK OF INJURY.

What is the highest temperature when VIVID E9 starts giving the "High System Temperature" Error?

All Card Rack (PCBs, or Front End) sensors:

New in v110.1.10 - DRX_TOP sensors:

New in v112.0:

It seems that the BEP is "hanging" - it's not responding at all. How do I Reset it?

1.) Try this method first:

Press the ON/OFF switch on the Operator Panel for more than six seconds. This should cause the

VIVID E9 to perform a "Forced Restart".

2.) If the instruction in step 1 didn't help, as the last solution, after waiting several minutes, switch off

the power on the rear of the system.

The limit for the first warning is 78 degrees centigrade (78 ºC).

The system starts the shutdown sequence at 80 degrees centigrade (80 ºC)

The limit for the first warning is 87 degrees centigrade (87 ºC).

The system starts the shutdown sequence at 90 degrees centigrade (90 ºC).

There is a new reminder showing "Clean air filter".

It is displayed at start-up of the VIVID E9, and is repeated at specific pre-defined intervals.

Section 7-2 - Service Safety Considerations