GE VIVID E9 Service Manual page 606

GE H
EALTHCARE
D GA091568, R
IRECTION
8-11-4-9 Installing the Graphics Adapter in the BEP5
Follow these steps to install the new Graphics adapter:
1.) Plug in the new Graphics adapter.
2.) If a locking mechanism is installed on the connector on the BEP's motherboard, pull the plastic
slider up to fix the Graphics adapter in position.
3.) Connect the cables to the Graphics adapter.
Table 8-8
Graphics Adapter
Prolink Add2 card
ATI FireGL V7200
Nvidia Quadro FX1800
Nvidia Quadro 2000D
4.) Connect the two cables to the HDD.
5.) Swing the HDD bracket back in positon and fix it with the screw you removed earlier.
6.) Install the BEP Cover as described in these steps:
Be careful not to pinch any of the cables when installing the BEP Cover.
NOTICE
a.) Insert the base of the BEP Cover inside the base of the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9.
c.) Install the fixing screw(s) for the BEP Cover:
7.) Install the Left Side Cover.
8 - 272
5
EVISION
Connect the cables to the Graphics Adapter - BEP5
• Connect the DVI Out cable
• Connect the extra Power cable
• Connect the DVI Out cable
• Connect the DVI Out cable
• Connect the DVI Out cable to the connector
closest to the motherboard.
Be sure the bottom lip of the BEP Cover rests inside the BEP.
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
Section 8-11 - Back End Processor (BEP) parts replacement
Without DVR
VIVID E9 S
With DVR
• Connect the DVI Flex, Main cable
• Connect the extra Power cable
• Connect the DVI Flex, Jumper ("Z" cable")
• Connect the DVI Flex, Main cable
• Connect the DVI Flex, Main cable to the
connector closest to the motherboard.
M
ERVICE ANUAL