Brake Pedal Replacement - GE VIVID E9 Service Manual

GE H
EALTHCARE
D GA091568, R
IRECTION
8-9-4

Brake Pedal replacement

ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.
WARNING WARNING
WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO
VOLTAGE GREATER THAN 30 VOLTS:
1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.
TAG
&
LOCKOUT
2. TURN OFF THE BREAKER.
Date
Signed
3. UNPLUG THE VIVID E9.
4. MAINTAIN CONTROL OF THE POWER PLUG.
5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO
VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.
BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER
IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.
1.) Power down the VIVID E9
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external I/O cabling.
4.) Remove both Side Covers.
5.) Remove the Foot Rest Bumper.
6.) Remove the Top Cover
7.) Remove the Front Cover
8.) Remove the Pedal Mechanism.
8-9-4-1 Brake Pedal removal procedure
The pedal is fixed to the Pedal Mechanism with four (4x) hex key screws from below.
1.) Unscrew and remove the four screws.
2.) Remove the Brake Pedal.
8 - 216
5
EVISION
Section 8-9 - Casters and Brakes replacement
VIVID E9 S M
ERVICE ANUAL