Test The Lcd Arm And Lcd Monitor Range Of Motion - GE VIVID E9 Service Manual

GE H
EALTHCARE
D GA091568, R
IRECTION
Section 6-3

Test the LCD Arm and LCD Monitor range of motion

NOTE: This procedure is valid for both the 17 inch and the 19 inch LCD monitors.
Confirm LCD Arm and LCD Monitor have full range of motion.
1.) Move the LCD arm from side to side.
2.) Move the LCD from a face forward, vertical position to a face down, horizontal position
-
-
6 - 4
5
EVISION
Too tight: If the customer finds the LCD difficult to move from a vertical to horizontal position,
use a 17mm wrench to loosen nuts at hinge. Be sure to loosen both sides equally. Start with
1/4 turn and test full 90 degree movement before loosening more.
Too loose: If the customer finds the LCD does not remain in place after adjusting the LCD from
a vertical to horizontal position, use a 17mm wrench to tighten nuts at hinge. Be sure to tighten
both sides equally. Start with 1/4 turn and test full 90 degree movement before tightening
more.
Figure 6-3 Test LCD Vertically and Horizontally
Figure 6-4 Adjusting LCD Hinge Nuts
Section 6-3 - Test the LCD Arm and LCD Monitor range of motion
VIVID E9 S M
ERVICE
(Figure
LCD vertical
ANUAL
6-3).