Options Holder / Left Or Right Support Replacement - GE VIVID E9 Service Manual

Hide thumbs Also See for VIVID E9:

Table of Contents

Options Holder / Left or Right Support replacement

The Options Holder (the Left Support or Right Support) is the base piece that attaches to the upper

console to support either a Transvaginal Probe Holder or a Storage Tray. The VIVID E9 can support

one Left Options Holder and one Right Options Holder at the same time.

Preparations

When preparing for the replacement, you must perform the following steps:

ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.

WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO

VOLTAGE GREATER THAN 30 VOLTS:

1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.

2. TURN OFF THE BREAKER.

3. UNPLUG THE VIVID E9.

4. MAINTAIN CONTROL OF THE POWER PLUG.

5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO

VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.

BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER

IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.

1.) Power down the VIVID E9.

2.) Disconnect the Mains Power Cable from the wall outlet.

3.) Separate and remove the Storage Tray.

Chapter 8 - Replacement procedures