Rear Air Filter Replacement - GE VIVID E9 Service Manual

Hide thumbs Also See for VIVID E9:

Table of Contents

Rear Air Filter replacement

Preparations

When preparing for the replacement, you must perform the following steps:

ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.

WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO VOLTAGE

GREATER THAN 30 VOLTS:

1. TURN OFF THE BREAKER.

2. UNPLUG THE SYSTEM.

3. MAINTAIN CONTROL OF THE SYSTEM POWER PLUG.

4. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE AS THERE ARE NO

TEST POINTS TO VERIFY ISOLATION.

Beware that the Main Power Supply and Back End Processor may be energized even if the

power is turned off when the cord is still plugged into the AC Outlet.

1.) Power down the VIVID E9

2.) Disconnect the Mains Power Cable from the wall outlet.

3.) Remove the Filter Cover.

Filter removal procedure

Grab the Filter and remove it.

Section 8-8 - Main Console parts replacement