GE VIVID E9 Service Manual page 645

GE H
EALTHCARE
D GA091568, R
IRECTION
8-14-2-6 BEP5 - Digital Video Recorder installation procedure
Follow these steps to install the Digital Video Recorder:
1.) Seat the (new) DVR Board in the correct slot.
2.) Connect the cables to the DVR Board.
3.) Install the HDD (if removed).
4.) Install the BEP Cover as described in these steps:
Be careful not to pinch any of the cables when installing the BEP Cover.
NOTICE
a.) Insert the base of the BEP Cover inside the base of the BEP.
b.) Tilt the top of the BEP Cover toward the VIVID E9.
c.) Install the fixing screw(s) for the BEP Cover:
5.) Install the Left Side Cover.
5
EVISION
Be sure the bottom lip of the BEP Cover rests inside the BEP.
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
Chapter 8 - Replacement procedures
VIVID E9 S M
ERVICE ANUAL
8 - 311