Sata Cable - Dvr To Bep6 Mbd Replacement - GE VIVID E9 Service Manual

GE H
EALTHCARE
D GA091568, R
IRECTION
8-11-12

SATA Cable - DVR to BEP6 MBD replacement

8-11-12-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover's fixing screw(s).
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.) Remove the BEP and place it on a table.
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
• 8-11-1 "Back End Processor (BEP) replacement" on page
8-11-12-2 SATA Cable - DVR to BEP6 MBD removal
Follow these steps to remove the SATA Cable - DVR to BEP6 MBD:
1.) Unplug the SATA Cable from the DVD connector on the DVR.
2.) Unplug the other end of the SATA Cable from the CN SATA5 connector on the motherboard.
8-11-12-3 SATA Cable - DVR to BEP6 MBD installation
Follow these steps to install the SATA Cable - DVR to BEP6 MBD:
1.) Connect the SATA Cable to the CN SATA5 connector on the motherboard.
2.) Connect the other end of the SATA Cable to the DVD connector on the DVR.
3.) Install the BEP Cover.
4.) Install the Left Side Cover.
5
EVISION
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
Chapter 8 - Replacement procedures
VIVID E9 S
ERVICE
8-244.
M
ANUAL
8 - 287