Main Monitor Assembly Replacement - GE LOGIQ E10 Basic Service Manual

D 5750007-1EN, R
IRECTION
8-7-2

Main Monitor assembly replacement

NOTE: Before removing the Monitor, record old monitor settings or user settings if possible.
Manpower /
Time Total
One person /
40 minutes
Table 8-100 Preparations and Preparation Links
Energy Control and Power Lockout for LOGIQ E10:
WARNING WARNING
When servicing parts of the Ultrasound System where there is exposure to voltage greater than 30
Volts:
1. TURN OFF THE SCANNER.
2. UNPLUG THE SYSTEM.
TAG
&
3. MAINTAIN CONTROL OF THE SYSTEM POWER PLUG.
LOCKOUT
4. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE AND THE ON/OFF
Signed Date
BUTTON (WHITE LIGHT ON THE OP PANEL) TO TURN OFF, AS THERE ARE NO TEST POINTS
TO VERIFY ISOLATION.
J10
5. REMOVE THE BATTERY COVER AND DISCONNECT THE POWER CABLES J10 and J11 (black
TAG
&
LOCKOUT J11 and red) FROM THE BACKPLANE. See:
Signed Date
J10
replacement" on page
J11
Beware that the Main Power Supply, the Batteries, Power Module, ECB Shear Wave Capacitor Pack
may be energized, even if the power is turned OFF if the cord is still plugged into the AC Outlet.
1. Power down the system.
2. Move the User Interface (Top Console) to its lower position.
3. Disconnect the mains power cable from the wall outlet and all Probes and External I/O Cabling.
Preparation Link (if you need more information):
• 4-2-4 "Power SHUT DOWN" on page 4-9.
• 8-6-3 "Side Cover(s)/Side Air Intake (Filter) inspection / replacement" on page
8 - 84
. 1
EV
Table 8-99 Manpower / Time and Tools
Refer to: 8-2-5 "Tools needed for servicing the LOGIQ E10" on page 8-6
8-2-6 "PPE Required During Service" on page
Preparations - you must perform the following steps
8-327.
Section 8-7 - Replacing Top Console Parts
LOGIQ E10 B
Tools / PPE
8-6.
8-2-2 "Warnings" on page 8-3
8-33.
S M
ASIC ERVICE ANUAL
/
and 8-11-15 "Rear I/O