GE VIVID E9 Service Manual page 520

GE H
EALTHCARE
D GA091568, R
IRECTION
8-7-5-2 Drive Gear Assembly removal procedure
Figure 8-194 Drive Gear Assembly location
The Drive Gear Assembly is a part of the Z Mechanism. To remove the Drive Gear Assembly, follow
these steps:
1.) Disconnect the motor cable from the XYZ Control Box.
2.) Unscrew and remove the four fixing screws.
Figure 8-195 Remove four screws
3.) Pull the unit away. You may need to either operate the Z-release lever when pulling, or move the
Top Console slightly up or down to make the wheel disengage from the gear.
8-7-5-3 Drive Gear Assembly installation procedure
1.) Position the Drive Gear Assembly in the correct position. You may need to either operate the Z-
release lever when positioning, or move the Top Console slightly up or down to engage the teeth
on the wheel with the teeth on the gear.
Figure 8-196 Install the Drive Gear Assembly
2.) Install the four (4x) fixing screws with washers. (M6 x 16, Torque: 9,5 Nm.)
8 - 186
5
EVISION
Section 8-7 - Replacing XYZ Parts
VIVID E9 S M
ERVICE ANUAL