GE VIVID E9 Service Manual page 465

GE H
EALTHCARE
D GA091568, R
IRECTION
8-6-18-2 Encoder Board removal procedure
1.) Disconnect the cable to the Encoder Board.
2.) Turn the Operator Panel, Lower with the front up.
Figure 8-145 Fixing screws
3.) Unscrew and remove 4 screws.
4.) Remove the Encoder Board.
8-6-18-3 Encoder Board installation procedure
1.) Position the Encoder board so the holes for the fixing screws aligns.
2.) Install the four screws.
3.) Turn the Operator Panel, Lower with the front down.
4.) Plug in the cable to the Operator Panel, Lower.
5.) Install the Operator Panel, Lower.
6.) Install the Operator Panel, Upper.
5
EVISION
Chapter 8 - Replacement procedures
VIVID E9 S M
ERVICE ANUAL
8 - 131