GE VIVID E9 Service Manual page 435

GE H
EALTHCARE
D GA091568, R
IRECTION
8-6-7-2 Remove the Upper OP Panel/Touch Panel Assembly (cont'd)
4.) Disconnect the cables at the back of the Upper OP Panel/Touch Panel Assembly. See
"Upper OP Panel/Touch Panel assembly cable placement" on page
Figure 8-112 Upper OP Panel/Touch Panel assembly cable placement
USB - UPPER OP
PANEL from BEP
USB - VIDEO
from BEP
USB - OUT TO
BULKHEAD BOARD
LOWER OP
PANEL
5.) Lift out the Touch Screen Assembly and place it on an ESD safe surface.
8-6-7-3 Install the Upper OP Panel/Touch Panel Assembly
Follow these steps to install the Upper OP Panel/Touch Panel Assembly:
1.) Place the Upper OP Panel/Touch Panel Assembly in the frame.
2.) Ensure that all Ground cables are connected as shown in
page
Figure 8-113 OP Grounding
5
EVISION
8-101.
Chapter 8 - Replacement procedures
VIVID E9 S
ERVICE
8-101.
POWER - ON/OFF LOGIC
to BEP
AN KEYBOARD USB
AND POWER
USB - TRACKBALL
Figure 8-113 "OP Grounding" on
CONNECT YELLOW/GREEN GROUND
WIRE FROM LOWER OP HERE
(NOT ILLUSTRATED)
M
ANUAL
Figure 8-112
8 - 101