Brake Band Removal (Pro Series) - Toro Z Master Z400 Series Service Manual

CHASSIS
4. If the measurement is not correct, proceed to the
following steps.
5. Remove the hairpin and cotter pin from the brake
linkage (Fig. 105).
3
1. Brake linkage
2. Yoke
6. Adjust the yoke clockwise to shorten the distance;
counterclockwise to lengthen distance (Fig 105).
7. Measure the distance vertically between the front
of the brake bar and the crown of the tire; the
measurement should be 7/8" to 1" (22 to 25mm)
(Fig. 104).
8. Repeat steps 5 through 7 if additional adjustment is
needed.
9. Engage the parking brake (lever up) and ensure the
brake bar engages the tire (Fig. 104).
3-22
Fig 105 Firgure 44
3. Hair pin and cotter pin

Brake Band Removal (Pro Series)

Note: Procedure can be used for left hand or right
hand.
1. Raise the right rear wheel (Fig. 106).
Fig 106
2. Remove the four wheel lug nuts. Remove the wheel
assembly.
Z Master Z400 Service Manual
PICT-0229