11. Replace the plastic tie holding the clutch harness to
frame.
12. Install the mower drive belt onto the electric PTO
clutch. Refer to Replacing the Mower Deck Drive
Belt page 7-24.
13. Plug in the engine wiring harness (Fig. 323).
Fig 323
14. Connect the red wires to the starter solenoid (Fig.
324).
Fig 324
Z Master Z400 Service Manual
15. Connect the fuel hose clamp onto the fuel hose
located at the fuel pump (Fig. 325).
16. Turn the fuel shut-off valve to the "On" position (Fig.
326).
PICT-0283
PICT-0331
ENGINE
Fig 325
PICT-0330
Fig 326
PICT-0329
5
5-31