Toro Z Master Z400 Series Service Manual page 179

MOWER DECKS/PTO
5. Install the bearing spacer into the spindle housing
opening (Fig. 482).
6. Install the upper ball bearing with the open end of
the bearing to the inside of the housing (Fig. 483).
7
7-22
Fig 482 PICT-0176 rev
Fig 483 PICT-0180
7. Install the upper thrust washer and bearing shield
onto the spindle shaft (Fig. 484).
Fig 484
8. Install the pulley hub onto the spindle shaft.
Note: The raised center of the hub faces away from
the spindle (Fig. 485).
Fig 485
Z Master Z400 Service Manual
PICT-0181 rev
PICT-0183 rev