Parking Brake Removal - Toro GrandStand 74504TE Service Manual

CHASIS
Parking Brake Removal (Figure 3)
1. Place the jack stands underneath the frame.
2. Remove the fuel tank, see "Fuel Tank Removal,"
page 3-10.
3. Lower deck to the lowest position.
4. Remove the IHT fan.
5. Remove the IHT drive belt from pulleys.
3
6. Remove the skid plates.
7. Move the parking brake handle to the OFF position.
8. Loosen the cable clamp on the tower.
9. Unhook the springs from the brake handle
assembly.
10. Remove brake cable from clamp.
11. Remove the cotter pin from the brake caliper on
IHT parking brake arm.
12. Remove the mounting screw from tower.
13. Undo flange nut from bottom of the caliper
(Figure 4).
14. Brake caliper should be free and removed from
tower.
15. Unplug wiring harness from brake handle
assembly
3-2
Figure 4
16. Remove the 2 bolts from the top of the tower
holding brake handle assembly and bolt holding
the brake handle assembly on the front of the
tower.
17. Remove grip from brake handle assembly.
18. Drop brake handle through the hole in the tower.
Remove from tower.
TORO®- Grandstand Service Instruction Manual