Setting The Lh Hydraulic Pump Neutral - Toro Z Master Z400 Series Service Manual

2. Slide the seat fully forward, unlatch the seat and tilt
the seat forward.
3. Disconnect the electrical connector at the seat
switch located between the two hydraulic pumps.
Temporarily install a jumper wire across the
terminals in the wiring harness connector (Fig. 194).
Fig 194
Setting the LH Hydraulic Pump
Neutral
1. Start the engine, open the throttle 1/2 way and
release parking brake.
Note: The motion control lever must be in neutral
while making any adjustments.
Z Master Z400 Service Manual
HYDRAULIC SYSTEM
2. Adjust the pump rod length by rotating the knob in
the appropriate direction, until the wheel is still or
slightly creeping in reverse (Fig. 195).
3. Move the motion control lever forward and reverse,
PICT-0014a
then back to neutral. The wheel must stop turning or
slightly creep in reverse.
4. Run the engine at full speed. Make sure wheel
remains stopped or slightly creeps in reverse; adjust
if necessary.
Fig 195 PICT-0015a
4
4-15