Toro Z Master Z400 Series Service Manual page 58

8. Loosen the top hex head flange nut at the deck lift
plate mounting location. Pivot the INNER deck lift
plate up and back toward the RH motion control
lever (Fig. 121).
Fig 121
9. Lift the floor pan assembly to its fully opened
position.
10. Remove the panel assembly by removing the four
fasteners retaining the panel to the frame (Fig. 122).
Fig 122
Z Master Z400 Service Manual
11. Remove the bracket that supports the lower RH
corner of the panel assembly (Fig. 123).
PICT-0054 rev
12. Remove the hex bolts, bushings, and nylock nuts
connecting the deck lift arm plates to the mower
deck rear cross-shaft lift assembly (Fig. 124).
PICT-0034
CHASSIS
Fig 123 PICT-0055
Fig 124 PICT-0057
3
3-27