Pushing The Machine By Hand; Changing To Machine Operation - Toro Z Master Z400 Series Service Manual

Pushing the Machine by Hand

Important: Always push the machine by hand.
Never tow the machine because
hydraulic damage may occur.
1. Disengage the power take off (PTO) and turn the
ignition key to OFF. Move the levers to the neutral
position and apply the parking brake.
2. To hand push, rotate the by-pass valves counter-
clockwise 1 turn. This allows hydraulic fluid to by-
pass the pump enabling the wheels to turn (Fig.
208).
Important: Do not rotate the by-pass valves more
than 1 turn or the valves can come out of
the body and cause fluid to run out.
Fig 208
3. Disengage the parking brake before pushing.
Z Master Z400 Service Manual
HYDRAULIC SYSTEM

Changing to Machine Operation

1. Rotate the by-pass valves clockwise 1 turn to
operate the machine (Fig. 209).
Note: Do not over-tighten the by-pass valves.
Note: The machine will not drive unless the by-pass
valves are turned in.
PICT-0024a
Fig 209 PICT-0024a
4
4-21