Toro Z Master Z400 Series Service Manual page 61

CHASSIS
6. Rotate deck lift plate (inner) downward until lower
mounting holes line up with hole in carrier frame and
deck lift plate (outer). From the outside of the frame
install hex bolt, spacer, and flanged lock nut as
shown. Tighten bolt (Fig. 133).
A
3
A. Hex bolt
B. Flange locknut
7. Align rear deck mount swivels with ends of deck lift
rods (Fig. 134).
3-30
B
C
Fig 133 PICT-0066
C. Spacer
Fig 134 PICT-0067
8. Raise deck lift lever assembly until deck mount
swivels rest against deck rod jam nuts. Install HOC
pin into deck lift plate HOC holes that correspond to
the 3" (7.62cm) HOC position (Fig. 135).
A
Fig 135
A. Swivel
9. Install lower "stop" bolt through inner and outer deck
lift plates. Install nylock nut and tighten until hex nut
and bolt are seated firmly against the deck lift plates.
DO NOT over-tighten or deck lift plates will deform
inward causing HOC pin assembly to bind (Fig. 136).
Fig 136
Z Master Z400 Service Manual
B
PICT-0068
B. 3" (7.62mm)
HOC location
PICT-0069