For a compound locked bearing:
b. Thoroughly clean the spindle housing and the
outer race of the bearing.
c. Apply an even coat of chemical locking
compound to the outer race and inner spindle
housing (Fig. 478).
Caution: DO NOT get chemical locking compound
on the inside of the bearing.
Fig 478
d. Install the open end of the bearing to the inside
of the housing until the bearing is fully seated
(Fig. 479).
Fig 479
Z Master Z400 Service Manual
MOWER DECKS/PTO
3. Install the bearing shield and thrust washer onto the
spindle shaft (Fig. 480).
4. Install the housing (bearing installed) onto the
spindle shaft (Fig. 481).
PICT-0168
PICT-0170
Fig 480
PICT-0173 rev
Fig 481
PICT-0175
7
7-21