Racal Instruments 2461 User Manual page 96

2461Type C User Manual
Racal Instruments  1998
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
"TINT"
"TOT"
"PHAS"
"CHEC"
Note: If the specified channel is different from the channel
previously configured, the 2461 TYPE C returns an error
("Channel not configured").
*************************************************************
[SENSe][:PERiod]:APERture MINimum | MAXimum | DEFault |
<value>
[SENSe][:FREQuency]:APERture MINimum | MAXimum |
DEFault | <value>
[SENSe][:FREQuency:RATio]:APERture
DEFault | <value>
[SENSe][:TINTerval]:APERture
| <value>
[SENSe][:RTIMe]:APERture
<value>
[SENSe][:RISE:TIME]:APERture
DEFault | <value>
[SENSe][:FTIMe]:APERture
<value>
[SENSe][:FALL:TIME]:APERture
DEFault | <value>
[SENSe][:PWIDth]:APERture
<value>
[SENSe][:NWIDth]:APERture
<value>
[SENSe][:PHASe]:APERture
<value>
[SENSe][:TOTalize]:APERture
| <value>
[SENSe][:CHECk]:APERture
<value>
Description:
These commands all do the same thing. They set the 2461
TYPE C measurement aperture <time>. The units are seconds
and range from 1E-6 to 10. If the user specifies a value, then
this will be rounded up or down to the nearest of 1µs, 10µs,
100µs, 1ms, 10ms, 100ms, 1s or 10s.
Note that the aperture for the phase and totalize function is
determined by the input signal alone.
The resolution setting may be changed indirectly by the
CONFigure:ARRay and MEASure:ARRay commands and by
the SENSe:RESolution command.
Programming The Type C Function Card 4-53
MINimum | MAXimum |
MINimum | MAXimum | DEFault
MINimum | MAXimum | DEFault |
MINimum | MAXimum |
MINimum | MAXimum | DEFault |
MINimum | MAXimum |
MINimum | MAXimum | DEFault |
MINimum | MAXimum | DEFault |
MINimum | MAXimum | DEFault |
MINimum | MAXimum | DEFault
MINimum | MAXimum | DEFault |