Racal Instruments 2461 User Manual page 69

Programming The Type C Function Card 4-26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Example:
"FETCh? 50,1,2"
Returns the results of 50 measurements previously preformed.
The first value returned is the first measurement. Then every 2
values after the first are returned.
FETCh[:VOLTage][:MINimum]? [<count>[,<start>[,<step>]]]
FETCh[:VOLTage][:MAXimum]?[<count>[,<start>[,<step>]]]
FETCh[:FREQuency]?
FETCh[:FREQuency][:RATio]? [<count>[,<start>[,<step>]]]
FETCh[:FTIMe]?
FETCh[:FALL:TIME]?
FETCh[:RTIMe]?
FETCh[:RISE:TIME]?
FETCh[:PERiod]?
FETCh[:PWIDth]?
FETCh[:NWIDth]?
FETCh[:TINTerval]?
FETCh[:TOTalize]?
FETCh[:PHASe]?
FETCh[:CHECk]?
Description:
These commands return the results of the previous
measurement(s) taken. The function and the parameters
specified must match those of the previous CONFigure or
MEASure? commands.
The reading placed in the VXI output buffer is in exponential
form. For example, a 5 Mhz reading will be returned as follows:
+00005.0000000E+06. The number of returned bytes in the
VXI output buffer is fixed at 18 bytes.
Parameters:
The default value of <count> is the number of measurements for
the array. The default value of <start> is 1. The default value
for <step> is 1. The number of values returned is <count>. The
first of the values returned is value <start>, then all <step>
values after start are returned.
2461Type C User Manual
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
[<count>[,<start>[,<step>]]]
Racal Instruments  1998