Racal Instruments 2461 User Manual page 193

INPUT1:ROUT SEP
INPUT1:COMP:LEVEL
INPUT1:ATTEN
The default settings for Negative Pulse Width function, in addition to the above common
settings, are:
Command
CONF:TINT
INPUT1:COMP:SLOPE NEG
INPUT2:COMP:SLOPE POS
The following commands, when sent to the 2461 Type C while Negative Width is enabled
will generate errors:
Command
INPUT1:COMP:SLOPE POS
INPUT2:COMP:SLOPE NEG
INPUT1:COMP:SETUP:AUTO OFF/ONCE Attempt to change Auto trigger state on 1/P1
INPUT1/2:COMP:LEVEL
INPUT1:ATTEN
INPUT1:ROUT SEP
Rise/Fall Time
In addition to the above common settings, the default settings when the Rise Time function
is selected are:
Command
CONF1:TINT
INPUT1:COMP:SLOPE POS
INPUT2:COMP:SLOPE POS
The following commands, when sent to the 2461 Type C while Rise Time is enabled, will
generate errors:
Command
INPUT1:COMP:SLOPE NEG
INPUT2:COMP:SLOPE NEG
INPUT1:COMP:SETUP:AUTO OFF/ONCE Attempt to change Auto trigger state on
INPUT1:COMP:LEVEL
B-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Attempt to change to separate inputs
Attempt to set a trigger level
Attempt to change the attenuator
Measurement Function
Time Interval 1-2
Negative Slope, INPUT 1
Positive Slope, INPUT 2
Measurement Function
Attempt to change slope on INPUT 1.
Attempt to change slope on INPUT 2.
Attempt to set a trigger level
Attempt to change the attenuator
Attempt to change to separate inputs
Measurement Function
Time Interval 1-2
Positive Slope, INPUT 1
Positive Slope, INPUT 2
Measurement Function
Attempt to change slope on INPUT 1
Attempt to change slope on INPUT 2
INPUT1
Attempt to set a trigger level on INPUT 1 & 2
User Manual 2461 Type C