Xilinx AC701 User Manual page 24

Chapter 1: AC701 Evaluation Board Features
Programmable User Clock Source
[Figure
The AC701 board has a programmable low-jitter 3.3V differential oscillator (U34) driving
the FPGA MRCC inputs of bank 14. This USER_CLOCK_P and USER_CLOCK_N clock
signal pair are connected to FPGA U1 pins M21 and M22 respectively. On power-up the
user clock defaults to an output frequency of 156.250 MHz. User applications can change
the output frequency within the range of 10 MHz to 810 MHz through an I
Power cycling the AC701 board will revert the user clock to its default frequency of
156.250 MHz.
•
•
The user clock circuit is shown in
X-Ref Target - Figure 1-12
References
The Silicon Labs Si570 data sheet is available from their website
24
1-2, callout 7]
Programmable Oscillator: Silicon Labs Si570BAB000544DG (10 MHz - 810 MHz)
Differential Output
VCC3V3
R15
4.7KΩ 5%
USER CLOCK SDA
To I 2 C
Bus Switch
USER CLOCK SCL
(U49)
GND
Figure 1-12: User Clock Source
www.xilinx.com
Figure 1-12.
U34
Si570
Programmable
Oscillator
1 6
NC VDD
2
OE
7
USER CLOCK N
SDA 5
CLK-
8
4 USER CLOCK P
SCL CLK+
3
GND
2
C interface.
VCC3V3
C192
0.01 µF 25V
X7R
GND
10 MHz - 810 MHz
UG952_c1_11_101512
[Ref 7].
AC701 Evaluation Board
UG952 (v1.2) August 28, 2013