Configuring More Connections; More Connections Edit; Figure 29 Wan > More Connections; Table 18 Wan > More Connections - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

5.5 Configuring More Connections

This section describes the protocol-independent parameters for a remote network. They are
required for placing calls to a remote gateway and the network behind it across a WAN
connection. When you use the WAN > Internet Connection screen to set up Internet access,
you are configuring the first WAN connection.
Click Network > WAN > More Connections to display the screen as shown next.
Figure 29 WAN > More Connections
The following table describes the labels in this screen.
Table 18 WAN > More Connections
LABEL
#
Active
Name
VPI/VCI
Encapsulation
Modify
Apply
Cancel

5.5.1 More Connections Edit

Use this screen to configure a connection. Click the edit icon in the More Connections screen.
P-793H User's Guide
DESCRIPTION
This is the index number of a connection.
This display whether this connection is activated. Clear the check box to disable
the connection. Select the check box to enable it.
This is the descriptive name for this connection.
This is the VPI and VCI values used for this connection.
This is the method of encapsulation used for this connection.
The first (ISP) connection is read-only in this screen. Use the WAN > Internet
Connection screen to edit it.
Click the edit icon to go to the screen where you can edit the connection.
Click the delete icon to remove an existing connection. You cannot remove the
first connection.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Chapter 5 WAN Setup
81