Table of Contents
Advertisement
Chapter 2 Introducing the Web Configurator
Table 4 Status > Packet Statistics (continued)
LABEL
Rx B/s
Up Time
LAN Port Statistics
Interface
Status
TxPkts
RxPkts
Collisions
Help
Poll Interval(s)
Set Interval
Stop
2.4.3 Status: VPN Status
This is the same screen discussed in
2.5 Resetting the ZyXEL Device
If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the ZyXEL Device to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to "1234".
2.5.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
then release it. When the POWER LED begins to blink, the defaults have been restored
and the ZyXEL Device restarts.
52
DESCRIPTION
This field displays the number of bytes received in the last second.
This field displays the elapsed time this port has been up.
This field displays the type of port.
This field displays Down (line is down), Up (line is up or connected) if you're
using Ethernet encapsulation and Down (line is down), Up (line is up or
connected), Idle (line (ppp) idle), Dial (starting to trigger a call) and Drop
(dropping a call) if you're using PPPoE encapsulation.
This field displays the number of packets transmitted on this port.
This field displays the number of packets received on this port.
This is the number of collisions on this port.
Click this to open the embedded help.
Type the time interval for the browser to refresh system statistics.
Click this button to apply the new poll interval you entered in the Poll Interval
field above.
Click this button to halt the refreshing of the system statistics.
Figure 86 on page
173.
P-793H User's Guide
Advertisement
Table of Contents
Troubleshooting
