Table of Contents
Advertisement
Chapter 28 NAT Setup
Figure 169 Menu 15.1.1.1: Address Mapping Rule
The following table describes the fields in this menu.
Table 112 Menu 15.1.1.1: Address Mapping Rule
FIELD
Type
Local IP
Start
End
Global IP
Start
End
Server
Mapping
Set
Once you have finished configuring a rule in this menu, press [ENTER] at the message "Press ENTER
to Confirm..." to save your configuration, or press [ESC] to cancel.
28.3 Configuring a Server behind NAT
If you do not assign a Default Server IP address, the ZyXEL Device discards
all packets received for ports that are not specified here or in the remote
management setup.
284
Menu 15.1.1.1 Address Mapping Rule
Type= Server
Local IP:
Start= N/A
End
= N/A
Global IP:
Start= 0.0.0.0
End
= N/A
Server Mapping Set= 2
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select from a total of five types. These are the
mapping types discussed in
servers of different types behind NAT to this computer. See
an example.
These fields are enabled depending on the Type.
Enter the starting local IP address (ILA).
Enter the ending local IP address (ILA). If the rule is for all local IPs, then put the Start IP
as 0.0.0.0 and the End IP as 255.255.255.255. This field is N/A for One-to-One and Server
types.
These fields are enabled depending on the Type.
Enter the starting global IP address (IGA). If you have a dynamic IP, enter 0.0.0.0 as the
Global IP Start. Note that Global IP Start can be set to 0.0.0.0 only if the types are Many-
to-One or Server.
Enter the ending global IP address (IGA). This field is N/A for One-to-One, Many-to-One
and Server types.
This field is available only when you select Server in the Type field. Select which server
mapping set to use for this rule.
Chapter 7 on page
103. Server allows you to specify multiple
Section 28.4.3 on page 288
P-793H User's Guide
for
Advertisement
Table of Contents
Troubleshooting
