Chapter 24 LAN Setup
Figure 150 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP alias parameters.
Table 100 Menu 3.2.1: IP Alias Setup
FIELD
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
Version
Incoming
protocol filters
Outgoing
protocol filters
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to
save your configuration, or press [ESC] at any time to cancel.
24.4.1 Port-based VLAN Setup
You use menu 3.6 to control whether or not the ZyXEL Device sends layer-2 traffic (MAC
addresses) between LAN ports. For example, if LAN port 1 and LAN port 2 are connected to
different departments, you might not want the ZyXEL Device to broadcast traffic to both
networks. In this case, you should disable the connection between these ports. These
departments then have to communicate with each other using IP addresses, instead of MAC
addresses.
From the main menu, enter 3 to open Menu 3 - LAN Setup and select sub-menu 6.
260
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
DESCRIPTION
Choose Yes to configure the LAN network for the ZyXEL Device.
Enter the IP address of your ZyXEL Device in dotted decimal notation.
Your ZyXEL Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyXEL Device.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyXEL Device.
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyXEL Device.
P-793H User's Guide