C
H A P T E R
Use this menu to configure SNMP. See
SNMP.
31.1 SNMP Configuration
To configure SNMP, enter 22 from the main menu to display Menu 22 - SNMP
Configuration as shown next. The "community" for Get, Set and Trap fields is SNMP
terminology for password.
Figure 200 Menu 22: SNMP Configuration
The following table describes the SNMP configuration parameters.
Table 118 Menu 22: SNMP Configuration
FIELD
Get Community Type the Get community, which is the password for the incoming Get- and GetNext
Set Community
Trusted Host
Trap
Community
Destination
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous
screen.
P-793H User's Guide
SNMP Configuration
Section 15.6 on page 199
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
DESCRIPTION
requests from the management station.
Type the Set community, which is the password for incoming Set requests from the
management station.
If you enter a trusted host, your ZyXEL Device will only respond to SNMP messages
from this address. A blank (default) field means your ZyXEL Device will respond to
all SNMP messages it receives, regardless of source.
Type the Trap community, which is the password sent with each trap to the SNMP
manager.
Type the IP address of the station to send your SNMP traps to.
31
for more information about
309