Connect The Zyxel Devices; Point-To-2Points Connection Overview; Figure 23 Example: Point-To-2Points Connection - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

3 Set the VPI, VCI, Multiplexing, and Encapsulation to the same values you set in the
server.
4 Scroll down to the Service Type section. See
5 In the Service Mode field, select the same type of connection you selected for the server.
6 In the Service Type field, select Client. The rest of the fields will be negotiated with the
server.
7 Click Apply.

4.2.3 Connect the ZyXEL Devices

Connect the DSL ports on the ZyXEL Devices together, and wait while the ZyXEL Devices
automatically establish the connection. When the connection is established, the DSL1, DSL2,
and INTERNET lights are on. It takes up to half a minute to establish the connection. If the
ZyXEL Devices do not establish the connection, verify that the settings (except the Service
Type) match.

4.3 Point-to-2points Connection Overview

You can set up a point-to-2points connection between a server ZyXEL Device and two client
ZyXEL Devices. This configuration offers a secure and cost-effective way to create a private
IP network. An example is shown below.

Figure 23 Example: Point-to-2points Connection

In a point-to-2points connection, the DSL port on the server ZyXEL Device (A) uses a Y-
cable to create two DSL connections. The connections can use RFC 1483 in bridge mode or
ENET ENCAP in router mode. You can set up one set of transfer rate settings and modes
between the server ZyXEL Device A and the client ZyXEL Device B. You can set up a
different set of settings between the server ZyXEL Device A and the client ZyXEL Device C.
P-793H User's Guide
B
A
C
Chapter 4 Point-to-(2)point Configuration
Figure 22 on page 64 above.
65