Configuring More Connections Advanced Setup; Figure 31 Wan > More Connections: Edit: Advanced Setup; Table 14 Wan > More Connections: Edit: Advanced Setup - ZyXEL Communications P-870HW-51a v2 User Manual

Table 13 WAN > More Connections: Edit (continued)
LABEL
Apply
Reset
Advanced Setup

5.5.2 Configuring More Connections Advanced Setup

To edit your ZyXEL Device's advanced WAN settings, click the Advanced Setup button in
the More Connections Edit screen. The screen appears as shown.
Figure 31 WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 14 WAN > More Connections: Edit: Advanced Setup
LABEL
RIP & Multicast
Setup
RIP Version
RIP
Operation
P-870HW-51a v2 User's Guide
DESCRIPTION
Click this to save the changes.
Click this to begin configuring this screen afresh.
Click this button to display the More Connections Advanced Setup screen and
edit more details of your WAN setup.
DESCRIPTION
This section is not available when you configure the ZyXEL Device to be in bridge
mode.
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. The version field controls the format and the broadcasting
method of the RIP packets that the ZyXEL Device sends (it recognizes both
formats when receiving). RIP-1 is universally supported; but RIP-2 carries more
information. RIP-1 is probably adequate for most networks, unless you have an
unusual network topology
This field is available only when you select ENET ENCAP.
Select the RIP version from RIPv1, RIPv2 and RIPv1v2.
This field is available only when you select ENET
Select Active to enable RIP. Otherwise, select Disable.
Chapter 5 WAN Setup
ENCAP.
61