Table of Contents
Advertisement
Chapter 35 Menus 24.8 to 24.11
Figure 234 Menu 24: System Maintenance
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the
time and date settings of your ZyXEL Device as shown in the following screen.
Figure 235 Menu 24.10: System Maintenance - Time and Date Setting
Start Date (mm-nth-week-hr):
End Date (mm-nth-week-hr):
The following table describes the fields in this screen.
Table 128 Menu 24.10: System Maintenance - Time and Date Setting
FIELD
Time Protocol
Time Server
Address
340
Menu 24 - System Maintenance
1.
System Status
2.
System Information and Console Port Speed
3.
Log and Trace
4.
Diagnostic
5.
Backup Configuration
6.
Restore Configuration
7.
Upload Firmware
8.
Command Interpreter Mode
9.
Call Control
10. Time and Date Setting
11. Remote Management
Menu 24.10 - System Maintenance - Time and Date Setting
Time Protocol= None
Time Server Address= N/A
Current Time:
New Time (hh:mm:ss):
Current Date:
New Date (yyyy-mm-dd):
Time Zone= (GMT+0100) Brussels, Copenhagen, Madrid, Paris
Daylight Saving= No
DESCRIPTION
Enter the time service protocol that your timeserver uses. Not all time servers
support all protocols, so you may have to check with your ISP/network
administrator or use trial and error to find a protocol that works. The main
differences between them are the format.
Daytime (RFC 867) format is day/month/year/time zone of the server.
Time (RFC-868) format displays a 4-byte integer giving the total number of
seconds since 1970/1/1 at 0:0:0.
The default, NTP (RFC-1305), is similar to Time (RFC-868).
Select None to enter the new time and new date manually.
Enter the IP address or domain name of your timeserver. Check with your ISP/
network administrator if you are unsure of this information. The default is
tick.stdtime.gov.tw
06 : 43 : 17
06 : 43 : 00
2000 - 01 - 01
2000 - 01 - 01
Jan. - 1st
- Sun.(02)
Jan. - 1st
- Sun.(02)
P-793H User's Guide
- 00
- 00
Advertisement
Table of Contents
Troubleshooting
