Table of Contents
Advertisement
Chapter 36 IP Routing Policy Setup
36.6 IP Routing Policy
Use this menu to configure policy routes. To open this menu, select Edit and enter the
appropriate rule number in menu 25.
Figure 239 Menu 25.1.1: IP Routing Policy
The following table describes the labels in this menu.
Table 132 Menu 25.1.1: IP Routing Policy
FIELD
Policy Set Name
Active
Criteria
IP Protocol
Type of Service
Precedence
Packet Length
Len Comp
Source
addr start / end
port start / end
Destination
addr start / end
port start / end
346
Menu 25.1.1 - IP Routing Policy
Policy Set Name= ex1
Active= No
Criteria:
IP Protocol
= 0
Type of Service= Don't Care
Precedence
= Don't Care
Source:
addr start= 0.0.0.0
port start= N/A
Destination:
addr start= 0.0.0.0
port start= N/A
Action= Matched
Gateway addr
= 0.0.0.0
Type of Service= No Change
Precedence
= No Change
DESCRIPTION
This is the descriptive name of the routing policy selected in Menu 25.1 - IP
Routing Policy Summary.
Press [SPACE BAR] and then [ENTER] to select Yes to activate the policy.
Enter a number that represents an IP layer 4 protocol, for example, UDP=17,
TCP=6, ICMP=1 and Don't care=0.
Prioritize incoming network traffic by choosing from Don't Care, Normal, Min
Delay, Max Thruput or Max Reliable.
Precedence value of the incoming packet. Press [SPACE BAR] and then
[ENTER] to select a value from 0 to 7 or Don't Care.
Type the length of incoming packets (in bytes). The operators in the Len
Comp (next field) apply to packets of this length.
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
Less, Greater, Less or Equal or Greater or Equal.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Packet length= 0
Len Comp= N/A
end= N/A
end= N/A
end= N/A
end= N/A
Log= No
P-793H User's Guide
Advertisement
Table of Contents
Troubleshooting
