ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual page 92

Chapter 5 WAN Setup
Table 23 WAN > WAN Backup Setup > Advanced Setup > Edit (continued)
LABEL
CLID
Called ID
Speed
Call Control
Dial Timeout
Retry Count
Retry Interval
Drop Timeout
Call Back Delay
Back
Apply
Cancel
92
DESCRIPTION
Enter the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyXEL Device capture the CLID in the AT response
string that comes from the WAN device. CLID is required for CLID authentication.
Enter the keyword preceding the dialed number.
Enter the keyword preceding the connection speed.
Enter a number of seconds for the ZyXEL Device to keep trying to set up an
outgoing call before timing out (stopping). The ZyXEL Device times out and stops if
it cannot set up an outgoing call within the timeout value.
Enter a number of times for the ZyXEL Device to retry a busy or no-answer phone
number before blacklisting the number.
Enter a number of seconds for the ZyXEL Device to wait before trying another call
after a call has failed. This applies before a phone number is blacklisted.
Enter a number of seconds for the ZyXEL Device to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.
Enter a number of seconds for the ZyXEL Device to wait between dropping a
callback request call and dialing the corresponding callback call.
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
P-793H User's Guide