Table of Contents
Advertisement
4.4.2 Set up the Clients
1 Log in to one of the ZyXEL Devices that will be the client. (See
2 Click Network > WAN > Internet Connection.
3 Set the VPI, VCI, Multiplexing, and Encapsulation to the same values you set in the
server.
4 Scroll down to the Service Type section. A screen similar to the following appears.
5 In the Service Mode field, select 2 wire mode.
6 In the Service Type field, select Client. The rest of the fields will be negotiated with the
server.
7 Click Apply.
8 Repeat steps
4.4.3 Connect the ZyXEL Devices
Connect the DSL ports on the ZyXEL Devices together, and wait while the ZyXEL Devices
automatically establish the connection. Make sure that the Y-cable is connected to the proper
DSL outlets. The Y-cable connector marked DSL1 must be connected to the outgoing DSL 1
telephone jack and the Y-cable connector marked DSL2 must be connected to the outgoing
DSL 2 telephone jack.
When the connection is established, the DSL1, DSL2, and INTERNET lights turn on. It takes
up to half a minute to establish the connection. If the ZyXEL Devices do not establish the
connection, verify that the settings are correct.
P-793H User's Guide
1
to
7
for the second client device.
Chapter 4 Point-to-(2)point Configuration
Chapter 2 on page
43.)
67
Advertisement
Table of Contents
Troubleshooting
