Figure 154 Menu 11.1: Remote Node Profile (Nodes 1-7); Table 102 Menu 11.1: Remote Node Profile (Nodes 1-7) - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

Chapter 26 Remote Node Setup

Figure 154 Menu 11.1: Remote Node Profile (nodes 1-7)

Rem Node Name= MyISP
Active= Yes
Encapsulation= PPPoE
Multiplexing= LLC-based
Service Name=
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login=
My Password= ********
Authen= CHAP/PAP
Line=1
The following table describes the labels in this menu.

Table 102 Menu 11.1: Remote Node Profile (nodes 1-7)

FIELD
Rem Node Name
Active
Encapsulation
Multiplexing
Service Name
Incoming
Rem Login
Rem Password
Outgoing
My Login
My Password
Retype to Confirm
Authen
Line
Route
266
Menu 11.1 - Remote Node Profile
DESCRIPTION
Enter the name of the ISP.
Select whether or not you want to use this Internet connection.
Select the type of encapsulation your ISP uses.
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
(PPPoE only) Enter the service name provided by your ISP. Leave this field
blank if your ISP did not provide one.
This section is only enabled for PPPoA or PPPoE connections.
Type the login name that this remote node will use to call your ZyXEL Device.
The login name and the Rem Password will be used to authenticate this node.
Type the password used when this remote node calls your ZyXEL Device.
This section is only enabled for PPPoA or PPPoE connections.
Enter the user name provided by your ISP.
Enter the password provided by your ISP.
Enter the password again.
This field appears if you select PPPoE in the Encapsulation field. Select what
type of authentication your ISP uses. Select CHAP/PAP if you want the ZyXEL
Device to support both choices.
Select the DSL connection you want the ZyXEL Device to use for outgoing
traffic.
Press [SPACE BAR] and then [ENTER] to select IP to enable IP-based routing
to this remote node. This is not effective unless you enable IP-based routing in
the ZyXEL Device too. See
245.
You should enable Route IP, Bridge, or both in this screen. If you disable
Route IP and Bridge, the device does not send traffic between the LAN ports
and remote node.
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= No
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedule Sets=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 0
Menu 1: General Setup in Section 22.1 on page
P-793H User's Guide