Remote Node Filter - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

Table 104 Menu 11.3: Remote Node Network Layer Options (continued)
FIELD
Version
Multicast
IP Policies
Bridge Options
Ethernet Addr
Timeout(min)
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to
Confirm..." to save your configuration and return to menu 11.1, or press [ESC] at any time to cancel.

26.5 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.1.5 - Remote Node Filter.
Use this menu to specify the filter set(s) to apply to the incoming and outgoing traffic between
this remote node and the ZyXEL Device to prevent certain packets from triggering calls. You
can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. For more information on defining the filters, please
refer to Chapter 30 on page
option of specifying remote node call filter sets.
P-793H User's Guide
DESCRIPTION
Select which version of RIP the ZyXEL Device uses when it sends or receives
information on the subnet.
RIP-1 - The ZyXEL Device uses RIPv1 to exchange routing information.
RIP-2B - The ZyXEL Device broadcasts RIPv2 to exchange routing
information.
RIP-2M - The ZyXEL Device multicasts RIPv2 to exchange routing information.
You do not have to enable multicasting to use RIP-2M. (See RIP Version.)
Select which version of IGMP the ZyXEL Device uses to support multicasting
on this port. Multicasting only sends packets to some computers and is an
alternative to unicasting (sending packets to one computer) and broadcasting
(sending packets to every computer).
None - The ZyXEL Device does not support multicasting.
IGMP-v1 - The ZyXEL Device supports IGMP version 1.
IGMP-v2 - The ZyXEL Device supports IGMP version 2.
Multicasting can improve overall network performance. However, it requires
extra processing and generates more network traffic. In addition, other
computers have to support the same version of IGMP.
You can apply up to four policy routes for this remote node. Configure the
policy routes in menu 25 first. See
about policy routes.
This field is enabled if Bridge is Yes in SMT
(nodes 1-7). Type the time (in minutes) for the ZyXEL Device to retain the
Ethernet address information in its internal tables while the line is down. If this
information is retained, your ZyXEL Device will not have to recompile the
tables when the line comes back up.
295. For PPPoE or PPTP encapsulation, you have the additional
Chapter 26 Remote Node Setup
Chapter 36 on page 343 for information
Menu 11.1: Remote Node Profile
271