Chapter 23 WAN Setup
The following table describes the fields in this menu.
Table 97 Menu 2.2: Dial Backup Setup
FIELD
Dial-Backup:
Active
Port Speed
AT Command
String:
Init
Edit Advanced
Setup
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
23.5 Advanced Dial Backup Setup
Consult the manual of the device connected to your Dial Backup port for
specific AT commands.
To edit the advanced setup for the Dial Backup port, move the cursor to the Edit Advanced
Setup field in Menu 2.2 - Dial Backup Setup, press the [SPACE BAR] to select Yes and
then press [ENTER].
Figure 146 Menu 2.2.1: Advanced Dial Backup Setup
AT Command Strings:
Dial= atd
Drop= ~~+++~~ath
Answer= ata
Drop DTR When Hang Up= No
AT Response Strings:
CLID= NMBR =
Called Id=
Speed= CONNECT
254
DESCRIPTION
Use this field to turn the dial-backup feature on (Yes) or off (No).
Press [SPACE BAR] and then press [ENTER] to select the speed of the connection
between the Dial Backup port and the external device.
Available speeds are:
9600, 19200, 38400, 57600, 115200 or 230400 bps.
Enter the AT command string to initialize the WAN device. Consult the manual of your
WAN device connected to your Dial Backup port for specific AT commands.
To edit the advanced setup for the Dial Backup port, move the cursor to this field;
press the [SPACE BAR] to select Yes and then press [ENTER] to go to Menu 2.1 -
Advanced Setup.
Menu 2.2.1 - Advanced Dial Backup Setup
Call Control:
Dial Timeout(sec)= 60
Retry Count= 0
Retry Interval(sec)= N/A
Drop Timeout(sec)= 20
Call Back Delay(sec)= 15
P-793H User's Guide