Chapter 26 Remote Node Setup
Figure 157 Menu 11.5: Remote Node Filter
The following table describes the labels in this menu.
Table 105 Menu 11.5: Remote Node Filter
FIELD
Input Filter Sets
protocol filters
device filters
Output Filter Sets
protocol filters
device filters
Call Filter Sets
protocol filters
device filters
26.6 Remote Node ATM Layer Options
Move the cursor to the Edit ATM Options field in menu 11.1, then press [SPACE BAR] to
select Yes. Press [ENTER] to open this menu. This menu depends on the multiplexing and
encapsulation you select in menu 11.1.
272
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
DESCRIPTION
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
These fields appear if you selected PPPoA or PPPoE in Encapsulation in
menu 11.1.
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
Enter up to four filter sets. If you enter more than one, separate each one with
a comma ( , ).
P-793H User's Guide