Table of Contents
Advertisement
Chapter 5 WAN Setup
Table 15 WAN > Internet Connection (continued)
LABEL
Enable Rate
Adaption
Transfer Max Rate
(Kbps)
Transfer Min Rate
(Kbps)
Standard Mode
Apply
Cancel
Advanced Setup
5.4.1 2Wire-2Line Service Mode
The Service Mode section of the Internet Connection screen allows you to set up two DSL
connections when you select 2wire-2line mode. This allows you to create a point-to-2points
configuration. See
Figure 27 2wire-2line Service Mode
78
DESCRIPTION
This field is enabled if Service Type is Server. Indicate whether or not the
ZyXEL Device can adjust the speed of its connection to that of the other device.
This field is enabled if Service Type is Server. Set the maximum rate at which
the ZyXEL Device sends and receives information. The actual transfer rate will
be between this value and the minimum transfer rate you configure.
Note: When you select 4-wire in the Service Mode field, then the
transfer rate you set here is doubled. For example, select
5696 Kbps to configure a maximum transfer rate of 11392
Kbps.
This field is enabled if Service Type is Server. Set the minimum rate at which
the ZyXEL Device sends and receives information. The actual transfer rate will
be between this value and the maximum transfer rate you configure.
Note: When you select 4-wire in the Service Mode field, then the
transfer rate you set here is doubled. For example, select
192 Kbps to configure a minimum transfer rate of 384
Kbps.
This field is enabled if Service Type is Server. Select the operational mode the
ZyXEL Device uses in the DSL connection. Annex A refers to connections over
POTS and Annex B refers to connections over ISDN lines.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Click this button to display the Advanced WAN Setup screen and edit more
details of your WAN setup.
for more background information about this mode.
Section 5.4.1 on page 78
P-793H User's Guide
Advertisement
Table of Contents
Troubleshooting
