Configuring Dynamic Dns; Figure 141 Menu 1.1: Configure Dynamic Dns - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

Chapter 22 General Setup
Table 92 Menu 1: General Setup (continued)
FIELD
Route IP
Bridge
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.

22.1.1 Configuring Dynamic DNS

To configure Dynamic DNS, set the ZyXEL Device to router mode in menu 1 or in the
MAINTENANCE Device Mode screen and go to Menu 1 - General Setup and press
[SPACE BAR] to select Yes in the Edit Dynamic DNS field. Press [ENTER] to display
Menu 1.1 - Configure Dynamic DNS (shown next).

Figure 141 Menu 1.1: Configure Dynamic DNS

Service Provider= WWW.DynDNS.ORG
Active= No
DDNSType= DynamicDNS
Host 1=
Host 2=
Host 3=
Username=
Password= ********
Enable Wildcard Option= No
Enable Off Line Option= N/A
IP Address Update Policy:
DDNS Server Auto Detect IP Address= No
Use Specified IP Address= No
Use IP Address= N/A
246
DESCRIPTION
Select Yes to enable IP-based routing in the ZyXEL Device. This is not effective for
a specific remote node unless you enable IP-based routing in the remote node too.
See Menu 11.1: Remote Node Profile (nodes 1-7)
You should enable Route IP, Bridge, or both in this screen. If you disable Route IP
and Bridge, the device does not send traffic between the LAN ports and remote
node.
If Route IP is Yes, select Yes in this field to enable bridging in the ZyXEL Device for
protocols that are not supported by IP-based routing (for example, SNA).
If Route IP is No, select Yes in this field to enable bridging in the ZyXEL Device for
all protocols.
In either case, this setting is not effective for a specific remote node unless you
enable bridging in the remote node too. See
(nodes 1-7) in Section 26.3 on page
You should enable Route IP, Bridge, or both in this screen. If you disable Route IP
and Bridge, the device does not send traffic between the LAN ports and remote
node.
Menu 1.1 - Configure Dynamic DNS
in Section 26.3 on page
Menu 11.1: Remote Node Profile
265.
P-793H User's Guide
265.