Filter Configuration; Chapter 30 Filter Configuration; Introduction To Filters; Figure 186 Outgoing Packet Filtering Process - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

C
H A P T E R
This chapter shows you how to create and apply filters.

30.1 Introduction to Filters

Your ZyXEL Device uses filters to decide whether to allow passage of a data packet and/or to
make a call. There are two types of filter applications: data filtering and call filtering. Filters
are subdivided into device and protocol filters, which are discussed later.
Data filtering screens the data to determine if the packet should be allowed to pass. Data filters
are divided into incoming and outgoing filters, depending on the direction of the packet
relative to a port. Data filtering can be applied on either the WAN side or the LAN side. Call
filtering is used to determine if a packet should be allowed to trigger a call. Remote node call
filtering is only applicable when using PPPoE encapsulation. Outgoing packets must undergo
data filtering before they encounter call filtering as shown in the following figure.

Figure 186 Outgoing Packet Filtering Process

For incoming packets, your ZyXEL Device applies data filters only. Packets are processed
depending upon whether a match is found. The following sections describe how to configure
filter sets.
P-793H User's Guide

Filter Configuration

30
295