2Wire-2Line Service Mode; Figure 143 Menu 2: 2Wire-2Line Service Mode; Table 95 Menu 2: 2Wire-2Line Service Mode - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

23.1.1 2wire-2line Service Mode

From the main menu, enter 2 to open menu 2, then select 2wire-2line in the Service Mode
field to see the screen as shown below.

Figure 143 Menu 2: 2wire-2line Service Mode

The following table describes the fields in this screen.

Table 95 Menu 2: 2wire-2line Service Mode

FIELD
Service Mode
Service Type
Rate Adaption
Transfer Max
Rate(Kbps)
Transfer Min
Rate(Kbps)
Standard Mode
Wan Backup
Setup
P-793H User's Guide
Menu 2 - WAN Setup
Service Mode= 2wire-2line
Service Type= N/A
Rate Adaption= Disable
Transfer Max Rate(Kbps)= 4480
Transfer Min Rate(Kbps)= 4480
Standard Mode= ANSI(ANNEX_A)
Wan Backup Setup:
Check Mechanism = DSL Link
Check WAN IP Address1 = 0.0.0.0
Check WAN IP Address2 = 0.0.0.0
Check WAN IP Address3 = 0.0.0.0
KeepAlive Fail Tolerance = 0
Recovery Interval(sec) = 0
ICMP Timeout(sec) = 0
Traffic Redirect = No
Dial Backup = No
DESCRIPTION
Press [SPACE BAR] to select 2wire-2line service mode. This means you are
establishing a point-to-2point connection. See
background information. In 2wire-2line mode, the maximum data rate is up to 5.69
Mbps for each DSL connection.
The ZyXEL Device automatically acts as a server in 2wire-2line mode.
The field on the left refers to DSL 1 connection and the field on the right refers to
DSL 2 connection. Press [SPACE BAR] to let the ZyXEL Device adjust the speed of
its connection to that of the other device.
The field on the left refers to DSL 1 connection and the field on the right refers to
DSL 2 connection. Press [SPACE BAR] to set the maximum rate at which the ZyXEL
Device sends and receives information. If you enable Rate Adaption, the ZyXEL
Device adjusts to the speed of the other device and may exceed this rate.
The field on the left refers to DSL 1 connection and the field on the right refers to
DSL 2 connection. Press [SPACE BAR] to set the minimum rate at which the ZyXEL
Device sends and receives information. If you enable Rate Adaption, the ZyXEL
Device adjusts to the speed of the other device and may transfer information at less
than this rate.
The field on the left refers to DSL 1 connection and the field on the right refers to
DSL 2 connection. Press [SPACE BAR] to select the operational mode the ZyXEL
Device uses in the DSL connection.
Chapter 23 WAN Setup
Rate Adaption= Enable
Transfer Max Rate(Kbps)= 5696
Transfer Min Rate(Kbps)= 3200
Standard Mode= ANSI(ANNEX_A)
Chapter 4 on page 63 for more
251