Table 120 Menu 24.1: System Maintenance - Status (continued)
FIELD
WAN
Line Status
Transfer Rate
CPU Load
You may enter 1 to reset the counters or [ESC] to return to menu 24.
33.3 System Information and Console Port Speed
This section describes your system and allows you to choose different console port speeds. To
get to the System Information and Console Port Speed:
1 Enter 24 to go to Menu 24 - System Maintenance.
2 Enter 2 to open Menu 24.2 - System Information and Console Port Speed.
3 From this menu you have two choices as shown in the next figure:
Figure 204 Menu 24.2: System Information and Console Port Speed
33.3.1 System Information
System Information gives you information about your system as shown below. More
specifically, it gives you information on your routing protocol, Ethernet address, IP address,
etc.
P-793H User's Guide
DESCRIPTION
This section displays information about the WAN port.
Note: In a point-to-2points connection this field only displays line 1
status.
This field displays the port speed and duplex setting if you're using Ethernet
encapsulation and Down (line is down or not connected), Idle (line (ppp) idle),
Dial (starting to trigger a call) or Drop (dropping a call) if you're using PPPoE
encapsulation.
This field shows the transmission speed in kilobits per second on this port.
This field displays the percentage of CPU utilization.
Menu 24.2 - System Information and Console Port Speed
1. System Information
2. Console Port Speed
Chapter 33 System Information & Diagnosis
315