Figure 177 Example 3: Menu 11.3; Figure 178 Example 3: Menu 15.1.1.1 - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

1 In this case you need to configure Address Mapping Set 1 from Menu 15.1 - Address
Mapping Sets. Therefore you must choose the Full Feature option from the Network
Address Translation field (in menu 4 or menu 11.3) in
2 Then enter 15 from the main menu.
3 Enter 1 to configure the Address Mapping Sets.
4 Enter 1 to begin configuring this new set. Enter a Set Name, choose the Edit Action
and then enter 1 for the Select Rule field. Press [ENTER] to confirm.
5 Select Type as One-to-One (direct mapping for packets going both ways), and enter
the local Start IP as 192.168.1.10 (the IP address of FTP Server 1), the global Start IP
as 10.132.50.1 (our first IGA). (See
6 Repeat the previous step for rules 2 to 4 as outlined above.
7 When finished, menu 15.1.1 should look like as shown in

Figure 177 Example 3: Menu 11.3

IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
The following figure shows how to configure the first rule.

Figure 178 Example 3: Menu 15.1.1.1

P-793H User's Guide
Figure 178 on page
Menu 11.3 - Remote Node Network Layer Options
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start= 192.168.1.10
End = N/A
Global IP:
Start= 10.132.50.1
End = N/A
Server Mapping Set= N/A
Chapter 28 NAT Setup
Figure 177 on page
289).
Figure 179 on page
Bridge Options:
Ethernet Addr Timeout(min)= N/A
289.
290.
289