Remote Management Limitations; Figure 236 Menu 24.11 - Remote Management Control; Table 129 Menu 24.11 - Remote Management Control - ZyXEL Communications G.SHDSL.bis 4-port Security Gateway P-793H User Manual

Chapter 35 Menus 24.8 to 24.11
Figure 236 Menu 24.11 – Remote Management Control
TELNET Server:
Server Port = 23
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21
Secured Client IP = 0.0.0.0
Web Server:
Server Port = 80
Secured Client IP = 0.0.0.0
The following table describes the fields in this screen.
Table 129 Menu 24.11 – Remote Management Control
FIELD
TELNET Server
FTP Server
Web Server
Server Port
Server Access
Secured Client
IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

35.4.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:
1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
2 You have disabled that service in menu 24.11.
3 The IP address in the Secure Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the ZyXEL Device will disconnect the session
immediately.
4 There is an SMT console session running.
5 There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
6 There is a firewall rule that blocks it.
342
Menu 24.11 - Remote Management Control
DESCRIPTION
Each of these read-only labels denotes a service that you may use to remotely
manage the ZyXEL Device.
This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
ZyXEL Device.
Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
The default 0.0.0.0 allows any client to use this service to remotely manage the
ZyXEL Device. Enter an IP address to restrict access to a client with a matching IP
address.
Server Access = ALL
Server Access = ALL
Server Access = ALL
P-793H User's Guide