Configuring More Connections Advanced Setup - ZyXEL Communications AMG1312-T10D User Manual

Chapter 5 WAN Setup
Table 6 More Connections: Edit (continued)
LABEL
DHCP IPv6
DHCP PD
IPv6 Address
Prefix Length
IPv6 Default
Gateway
IPv6 DNS
Server1
IPv6 DNS
Server2
Connection
Keep Alive
Connect on
Demand
Max Idle Timeout
NAT
Back
Apply
Advanced Setup

5.3.2 Configuring More Connections Advanced Setup

Use this screen to edit your Device's advanced WAN settings. Click the Advanced Setup button in
the More Connections Edit screen. The screen appears as shown.
44
DESCRIPTION
Select DHCP if you want to obtain an IPv6 address from a DHCPv6 server.
The IP address assigned by a DHCPv6 server has priority over the IP address
automatically generated by the Device using the IPv6 prefix from an RA.
Select SLAAC (Stateless address autoconfiguration) to have the Device use the prefix to
automatically generate a unique IP address that does not need to be maintained by a
DHCP server.
Select Enable to use DHCP PD (Prefix Delegation) to allow the Device to pass the IPv6
prefix information to its LAN hosts. The hosts can then use the prefix to generate their
IPv6 addresses.
With Static IP Address enabled, enter the IPv6 address of the Device in the WAN.
With Static IP Address enabled, enter the IPv6 prefix length in the WAN.
With Static IP Address enabled, enter the IPv6 address of the default gateway
With Static IP Address enabled, enter the primary DNS server IPv6 address for the
Device.
With Static IP Address enabled, enter the secondary DNS server IPv6 address for the
Device.
Select Keep Alive when you want your connection up all the time. The Device will try to
bring up the connection automatically if it disconnects.
Select Connect on Demand when you don't want the connection up all the time and
specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select Connect on
Demand. The default setting of 0 means the Internet session will not timeout.
If you set the Mode field to Router, you can select SUA Only if you have one public IP
address and want to use NAT.
Otherwise, select None to disable NAT.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to display the More Connections Advanced Setup screen and edit more
details of your WAN setup.
AMG1312-T10D User's Guide