Configuring More Connections Advanced Setup - ZyXEL Communications AMG1302-T series User Manual

6.3.2 Configuring More Connections Advanced Setup

Use this screen to edit your AMG1302/AMG1202-TSeries's advanced WAN settings. Click the
Advanced Setup arrow icon in the More Connections Edit screen. The screen appears as shown.
Figure 24 Network Setting > Broadband > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 15 Network Setting > Broadband > More Connections: Edit: Advanced Setup
LABEL
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
ATM QoS
ATM QoS Type
Peak Cell Rate
Sustain Cell
Rate
Maximum Burst
Size
MTU
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
Select the RIP Direction from None, Both, In Only and Out Only.
This field is not configurable if you select None in the RIP Direction field.
Select the RIP Version from RIP-1, RIP2-B and RIP2-M.
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish
membership in a multicast group. The AMG1302/AMG1202-TSeries supports IGMP-v1,
IGMP-v2 and IGMP-v3. Select None to disable it.
Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice or data
traffic. Select UBR (Unspecified Bit Rate) for applications that are non-time sensitive, such
as e-mail. Select nrtVBR (Variable Bit Rate-non Real Time) or rtVBR (Variable Bit Rate-
Real Time) for bursty traffic and bandwidth sharing with other applications.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell Rate
(PCR). This is the maximum rate at which the sender can send cells. Type the PCR here.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be transmitted.
Type the SCR, which must be less than the PCR. Note that system default is 0 cells/sec.
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS, which is less than 65535.
Chapter 6 Broadband
85